Garage Pro 8000 EXT-L 4 Post Lift & RJ-35 Sliding Jack

Garage Pro 8,000 EXT-L

We are proud to announce the arrival of the new Garage Pro 8,000 EXT-L (extra long and slightly wider) Service/Storage Lift. This lift is 20 inches longer (wheelbase) and 3 inches wider than the GDS Garage Pro 8000 EXT. Or to compare to the original, this lift is 20 inches longer (wheelbase), 3 inches wider, and 14 inches taller than the GDS Garage Pro 8000! The extra runway length will accommodate almost all of the longer wheelbase pickup trucks, except duallys. This is because the dual rear wheels are TOO WIDE to fit between the column lock assemblies. Check out the GDS Garage Pro 9000 or the GDS 409-HP if you need a portable lift for your dually!

The portable GDS Garage Pro 8000 EXT-L includes a caster kitwith polyurethane wheels. The caster kit can be installed or removed in just a matter of minutes and requires no tools.

All GDS portable four post lifts (8,000 lb. capacity) are designed and built for use by Mr. Homeowner or restoration shops. These lifts are not designed to work in commercial repair shops that raise and lower a lift several times per day. If you have questions about which AtlasŪ lift will best suit your application, please ask your salesperson.


AtlasŪ RJ-35 Sliding Jack

The GDS RJ-35 (3500 LB. capacity) sliding hydraulic vehicle jack is the perfect choice for the owner of the GDS Garage Pro 8000. The GDS RJ-35 Sliding Jack will also fit the GDS Garage Pro 9000. The GDS RJ-35 Sliding Jack is for those who want to perform wheel service on a vehicle that is positioned on top of their four post lift.

The complete GDS Garage Pro 8000 four post lift comes with a jack tray.The jack tray has certain limitations that are eliminated by using the GDS RJ-35 Sliding Jack. The jack tray (with a small floor jack or jack stands) will support ONLY THOSE LIFTING POINTS of the raised vehicle that are between the runways of the GDS Garage Pro 8000 four post lift. The GDS RJ-35 Sliding Jack has telescoping arms that can be extended over the runways of the four post lift. The lift pads at the end of these arms can be positioned under the LIFTING POINTS (that are located over the runways of the four post lift) of the vehicle allowing the operator to access many more LIFTING POINTS than just using the jack tray.

The GDS RJ-35 Sliding Jack comes standard with a set of peg style truck adapters which increase the lifting height of the lift pads. These truck adapters will allow the GDS RJ-35 Sliding Jack sliding hydraulic jack to raise pick up trucks that will sit higher on the runways than the average passenger car. The GDS RJ-35 Sliding Jack is operated by a manual hydraulic pump (porta-power pump) and does not require an air compressor for power. The GDS RJ-35 Sliding Jack sliding hydraulic jack also features two solid locking positions that are used when the vehicle is to be suspended above the runways. When the locking positions of the GDS RJ-35 Sliding Jack are engaged, the hydraulic pressure from the lifting cylinder of the RJ-35 Sliding Jack is eliminated. (These locks act much like a pair of jack stands after you lift a vehicle off the ground with a service jack).

Finally, the versatile GDS RJ-35 Sliding Jack is adjustable to fit between the runways of many of the other four post lifts that have been sold in the last several years.

© Copyright 2019 - The Garage Door Store