412 12,000 LB. 4 Post Lift

The 412 12,000 pound capacity four post lifts are designed and built to commercial grade standards and will provide many years of service. Our lifts offer many exclusive features not found on many other competitor's lifts. Drive-through off-ramps are available as an option.

The 412 (12,000 LB. capacity four post lift) incorporates many structural and cosmetic features that are found on lifts costing thousands of dollars more money. The 412 is tested to ensure that this lift system will perform flawlessly at its rated capacities. The 412 has been manufactured to the same exacting specifications for many years.

The 412 uses a high strength cable system (with an under runway oversized hydraulic cylinder) powered by a 220 volt (single phase) power unit to raise and lower the lift. Many competitors use an "old style" chain lifting system with an exposed hydraulic cylinder system. Old style chain lifts are difficult to "level" properly and the exposed hydraulic cylinder is responsible for numerous "door dings".

RJ-6000 Rolling Jack

The RJ-6000 (Manual) is a heavy duty rolling jack designed to lift and support 6,000 LB. The commercial grade RJ-6000 (Manual) rolling jack can be used to raise the front or rear portion of a vehicle; allowing the operator of a four post above ground lift to perform wheel and brake service. Most commercial shops buy two of these hydraulic rolling jacks, so that the entire vehicle can be supported in the air at the same time.

The RJ-6000 (Manual) has telescoping arms that can be extended over the runways of the four post lift. The lift pads at the end of these arms can be positioned under the LIFTING POINTS that are located over the runways of the four post lift. The RJ-6000 (Manual) rolling bridge is equipped with expandable supports which adjust to fit many different brands of four post above ground lifts. These supports have a unique roller system that allows the rolling hydraulic jack to glide easily under the entire length of the vehicle. The large heavy steel wheels allow the rolling jack to be positioned under the correct lifting points in a matter of seconds.

The RJ-6000 (Manual) comes standard with a set of peg style truck adapters which increases the lifting height of the lift pads. These truck adapters will allow the RJ-6000 rolling hydraulic jack to raise most pick up and larger trucks that will sit higher than the average passenger car. The RJ-6000 can be equipped with an optional AtlasŪ Air/Hydraulic Pump. The air/hydraulic pump would require a supply of compressed air (air compressor) to work properly.

The RJ-6000 rolling hydraulic jack features two solid locking positions that are used when the vehicle is to be suspended above the runways. When the locking positions of the RJ-6000 are engaged, the hydraulic pressure from the lifting cylinder of the jack is eliminated. (These locks act much like a pair of jack stands after you lift a vehicle off the ground with a service jack).

© Copyright 2019 - The Garage Door Store